Showcase planning

These sketches are of 2 different layout plans for my showcase of my FMP. I would like to use the idea of binding the magazine to the wall, but there is the issue of it being unstable when fastened to the wall because it is made out of paper and paper is not a rigid material. I like my storyboard idea, but it's not the most creative design. It gets the job done and that's probably the way I will lay my magazine out.
I shouldn't need a lot of space because if all the pages are laid out like the sketch then it should measure out to be 84cm wide and 59.4cm high (roughly).
I would like to put a small banner on top of the laid out magazine so that I can either put my name in there or put the logo of the magazine so that the display looks more attractive.

I have made a rough physical design of how I would like my showcase to look. You can clearly notice that my plan here is different to my original sketches. I had to lay my magazine out like this because I forgot that one of my spreads taks up 2 pages, so I had to make sure that my plan worked around that. All I had to was move the top 4 pages into a more fitting way so that the double page spread could be fit on properly.
I'm not one hundred percent sure where I should put my name or the name of the magazine yet, but I was think that I could my name on one side and the name of the magazine on the other.